Cortex-M Trace Reference Board (6.68.18)
The SEGGER Cortex-M Trace Reference Board is designed to enable the quick set up of a reference project when making use of a J-Link or J-Trace unit. This is a Cortex-M4 reference board which includes support for the Embedded Trace Macrocell (ETM).
embOS/IP Switch Board (6.70.00)
SEGGER embOS/IP Switch Board comes complete with an evaluation version of emNet with the Tail Tagging feature. The Tail Tagging enhancement establishes a virtual Multiport when only one physical Ethernet port is available on the CPU.
emPower Evaluation Board (6.30.00)
SEGGER emPower Cortex-M4 Evaluation Board comes complete with evaluation versions of the following software components accelerating the start of any embedded project.
- embOS (Real Time Operating System)
- emFile (File System)
- emWin (Graphic Software & GUI)
- emUSB Device (USB Device Stack)
- emUSB Host (USB Host Stack)
- emNet (TCP/IP Stack)
emPower USB-Host (6.90.00)
SEGGER emPower USB-Host is a low-cost board for applications that require two USB-Host ports in a simple and small design. Evaluation versions of SEGGER software including emUSB-Host, emLoad and embOS are ready to run on the board. Accessing the board with a debug probe can be achieved via the 10-pin Cortex-M connector on the board.
iMX RT1050 Trace Reference Board (6.68.19)
The SEGGER iMX RT1050 Trace Reference Board is designed to enable the quick set up of a ARM Cortex-M7 reference project when making use of a J-Trace unit. This is a Cortex-M7 reference board which includes support for the Embedded Trace Macrocell (ETM).
NAND-Flash EVAL (6.20.12)
SEGGER NAND-Flash EVAL
This evaluation board is an easy to use and cost effective testing tool designed to permit the evaluation of the features and the performance of the emFile NAND driver with various NAND chips.
SD Card Adapter (6.20.13)
SEGGER SD Card Adapter
On some evaluation boards the pins required for measuring are not accessible, making it impossible to use an oscilloscope or logic analyzer to capture the outputs. The best solution in such a situation is to use an adapter which is inserted between the card slot and the card to gain access to these signals. This is the where the SD Card Adapter may be used.
STM32H7 Trace Reference Board (6.68.20)
The SEGGER STM32H7 Trace Reference Board is designed to enable the quick set up of a ARM Cortex-M7 reference project when making use of a J-Trace unit. This is a Cortex-M7 reference board which includes support for the Embedded Trace Macrocell (ETM).
Contact Us
Blog